January 11th, 2010 at 3:00 am » Comments (0)

This is a simple description and hand created graphic diagram showing the overall construction of a pool or spa/hot-tub pump. Basically, all of the centrifugal pumps work the same... so this guide should help you if you're trying to figure out the overall construction and design.   more »

January 11th, 2010 at 2:55 am » Comments (0)

A quick and dirty Q&A/FAQ about spa pumps and motors. Got a question about errant behavior of yours? Check this page out to see if your answer is here.   more »

January 11th, 2010 at 2:18 am » Comments (0)

In this episode of pump repair, I've got a Sta-Rite P2R swimming pool pump getting a new motor - the old one was burned out and finally died after many years of use!   more »

January 11th, 2010 at 1:28 am » Comments (0)

Sta-Rite ® Pump Seal Replacement Previous Page Next Page Note that the purpose of this section is to show you how to remove & install a spa pump seal for a Watkins Hot Springs ® "Classic" spa.    While every effort is made to be sure that virtually all areas of complexity are covered, you may [...]   more »

January 11th, 2010 at 1:21 am » Comments (0)

This one page tutorial shows how to assemble a basic center discharge spa pump wet end to a new 48 frame motor.   more »

January 11th, 2010 at 12:40 am » Comments (2)

On this job, replacement was difficult because the wet end impeller was fused to the motor armature... (rust, corrosion, etc). This Cal Spa had been in use for many years and didn't have the necessary water quality maintenance to prevent this from happening. 3 Pages, Enjoy!   more »

January 11th, 2010 at 12:17 am » Comments (0)

Here we're installing a new wet end/impeller and seal on an Aquaflo FMHP spa pump.   more »

January 9th, 2010 at 4:54 am » Comments (0)

This is the main index page for all of the spa pump repair sequences with thumbnails... easy to browse through!   more »